Published

How Much Does It Cost to Run a Sauna?

Less than most buyers fear — and easy to calculate exactly for your own home. This guide gives you the one formula that matters, worked examples for infrared and traditional saunas using published heater sizes, monthly cost for realistic routines, and the non-electric costs owners forget.

Affiliate disclosure: When you buy through links on this page, we may earn a commission at no extra cost to you. It never influences our rankings. Full disclosure.

The Simple Formula Every Owner Can Use

Forget guesswork. A sauna's electricity cost per session is:

Heater size (kW) × hours the heater is drawing power × your electricity rate ($ per kWh) = cost per session.

You can find all three numbers without any special equipment. Heater size is on the manufacturer's specification sheet and on the unit's rating plate. Hours means preheat plus session time — and with one honest caveat: once a traditional sauna reaches temperature, its heater cycles on and off to hold that temperature, so it is not drawing full power for the whole session. Treat the formula's result as a ceiling for traditional saunas, and close to exact for infrared cabins, whose panels run more continuously at lower power. Your rate is on your utility bill; US residential customers paid roughly 17 cents per kWh on average in recent federal data, but rates range from under 12 cents to over 35 cents depending on state and plan, so use your own bill's number. Our purchase-cost guide covers the buying side; this page is only about the running side.

Worked Examples by Sauna Type

Sauna type (illustrative)HeaterTime countedEnergyCost at $0.17/kWh
1–2 person infrared cabin1.5 kW1.0 hr, no long preheat1.5 kWh~$0.26
2–3 person infrared cabin2.2 kW1.0 hr2.2 kWh~$0.37
Small traditional cabin4.5 kW1.5 hr incl. preheat, full draw (ceiling)6.75 kWh~$1.15
Mid-size traditional / barrel6 kW1.5 hr incl. preheat, full draw (ceiling)9 kWh~$1.53
Large traditional sauna9 kW2.0 hr incl. preheat, full draw (ceiling)18 kWh~$3.06

Illustrations only, calculated from the heater sizes and the stated rate — not measurements of specific products. Traditional heaters cycle after preheat, so real costs are typically below the full-draw ceiling. Check your model's actual heater rating and your own utility rate.

Two patterns stand out. First, infrared is cheap to run in absolute dollars — a typical session costs less than a cup of coffee by a wide margin. Second, even a large traditional sauna, at the full-draw ceiling, costs only a few dollars a session. The purchase price and any electrician work to install a 240V circuit are where the real money is, as our 2026 rankings show model by model. Running cost should inform your choice, but for most buyers it should not dominate it.

Monthly and Yearly Cost: Model Your Own Routine

Multiply the per-session figure by how often you actually go. Three sessions a week is about 13 sessions a month: at the illustrations above, that is roughly $3–$5 a month for a small infrared cabin, about $15–$20 a month at the full-draw ceiling for a mid-size traditional sauna (less in practice because of cycling), and around $40 a month at the ceiling for daily large-traditional use. A useful honesty check: people overestimate future use when buying. If you are deciding between sizes, cost the smaller routine you are sure of, not the daily routine you hope for — the same advice we give in our small-spaces guide.

Wood-burning traditional saunas move the cost off the electric bill entirely, at the price of firewood, chimney upkeep, and a longer, hands-on preheat. If you already heat with wood, the marginal cost can be very low; if you buy firewood by the cord in a city, run the same math with your local price before assuming it is cheaper.

Check Price Check Price Prices change frequently — verify at checkout.

Infrared vs Traditional: Why the Gap Exists

Infrared cabins heat people, not a room full of air, so they use smaller heaters (commonly around 1.4–2.8 kW in home models) and are ready in minutes. Traditional heaters must bring the whole room — air, benches, stones, and walls — to 150–195°F, which is why they run 4.5–9 kW and need a real preheat. That difference in physics, not brand pricing, is the whole running-cost story. The experience differs just as much, which is why our infrared vs traditional comparison and sauna vs steam room guide are worth reading before you optimize for the electric bill. A steam generator, for comparison, also draws several kilowatts and adds water and descaling costs a dry sauna never has.

Ways to Spend Less Without Enjoying It Less

Right-size the sauna. Heating a 6-person cabin for one person wastes energy every session. Preheat with intent: start the heater, set a timer, and go in when it is ready instead of letting it sit at temperature. Keep heat in: a door that seals, sound barrel bands, and no propped-open door during breaks. Share the preheat: if two people sauna at different times, going back-to-back on one preheat beats two cold starts. Mind your tariff: on a time-of-use plan, an evening off-peak session can cost meaningfully less than a peak-hour one for exactly the same heat. None of these require buying anything — they are habits, and they compound over years of ownership.

Costs Beyond Electricity

Electricity is not quite the whole ownership bill. Budget, over years, for: replacement heater elements or infrared panels outside warranty (warranties vary widely — compare them in our traditional rankings); bench and floor cleaning supplies (our full sauna maintenance guide covers the cleaning, wood-care, and heater routine); exterior wood care on outdoor models; and, for traditional heaters, periodic stone replacement as stones degrade with repeated heating and water. Infrared benefits and ownership basics are covered on our benefits page. Even adding these, routine ownership remains modest next to the purchase price — which is precisely why buyers should negotiate hard on the purchase and warranty, not on pennies per session.

Bottom Line

Our verdict: At average US electricity rates, expect roughly $0.25–$0.40 per infrared session and roughly $1–$3 per traditional session (usually below the full-draw ceiling). That is real money over a decade, but it is small next to purchase and installation — choose the sauna you will actually use, then apply the formula with your own rate to know exactly what your habit costs.

For the combined picture in one place — purchase tiers plus monthly running costs — read how much a home sauna costs to buy and run each month.

Frequently Asked Questions

How much does it cost to run a home sauna per session?

It depends on heater size, session length including preheat, and your electricity rate. As an illustration using published heater sizes: a 1.5 kW infrared cabin running for 1 hour at $0.17 per kWh costs about $0.26 in electricity. A 6 kW traditional heater running at full draw for 1.5 hours including preheat at the same rate costs about $1.53. Heaters cycle once the room is at temperature, so real traditional-session costs are usually lower than the full-draw illustration. Use the formula in this guide with your own utility rate for a personal estimate.

How much does a sauna cost per month?

Multiply your per-session cost by sessions per month. At three sessions a week (about 13 a month), the illustrations in this guide give roughly $3–$4 a month for a small infrared cabin and roughly $13–$20 a month for a mid-size traditional sauna at an average US residential electricity rate. Heavy daily traditional use costs more; the formula in this guide lets you model your own pattern.

Is an infrared sauna cheaper to run than a traditional sauna?

Usually yes, for two reasons: infrared heaters are typically smaller (often around 1.4–2.8 kW for home cabins versus 4.5–9 kW for traditional heaters) and sessions need little or no preheat, so total energy per session is lower. A traditional sauna delivers higher temperatures and the löyly experience, so the comparison is cost versus experience, not cost alone.

Does a sauna use a lot of electricity?

Per session, a home sauna uses roughly the same order of electricity as running a clothes dryer or an oven for a comparable time — noticeable, but for most households not a major bill item at a few sessions a week. The exact amount is heater kilowatts multiplied by hours multiplied by your rate, reduced by heater cycling after preheat.

How can I lower my sauna running costs?

Use the smallest sauna that fits your routine, preheat only as long as needed, keep the door closed, maintain door seals and (on barrels) band tension so heat stays in, and run sessions back-to-back when two people sauna separately. If your utility offers time-of-use rates, running off-peak lowers the price per session without changing the energy used.